Reviewing the new ring management page step by step:
Section 5 Part 1 Reads:
Ring HTML code preview:
Every thing looks good... but the links do not work..... they take me to
pages that read:
http://www.ringsurf.com/netring?ring=***RING%20ID***;id=***SITE%20ID***;action=prev
There is no member!!
http://www.ringsurf.com/netring?ring=***RING%20ID***;action=list
A page that shows a broken ring image, no description, no members
I am not sure where the %20 came from. Using a space between ***RING ID***
and ***SITE ID*** is or was the correct way to write the code for your ring.
If these links were intended for preview - display only then should not take
you to broken or missing pages.
--------
Section 5 Part 2 Reads:
Ring HTML code: Below is the code that you enter on your site to activate
the ring.
This seems to be functioning just fine
-------
Section 5 part 3 Reads:
Required links on your site:
- Powered by RingSurf
- List Sites in Ring
I believe that this is the section that was complained about in an previous
message. This is a new requirement but does not seem to enforced at this
time. Trying to get your current members to change the code on their
webpage is next to impossible. I would suggest that ringmasters be
encouraged, asked or required to change their code so that new members will
have the required links but to allow them to leave their existing member's
code as is.
Debby T
--
HOT TOPIC - The new RingSurf
The RingSurf Problems and Suggestions List:
http://www.webringworld.org/index.php?module=ContentExpress&func=display&bid=18&btitle=Menu&ceid=72